Cleaning And Maintenance - Kiwi KMS 8302 Manual Del Uso

USE
• Use the setting button to choose the desired cutting width.
• The cutting width is adjustable from 1 to 15 mm.
• Slide the cradle to the left and place the food on the cradle.
• Place the holder on the cradle, use this holder to push the food slightly against the back cover.
• Activate the device by using the on/off switch which is located on the left side of the device.
• NOTE: this appliance is equipped with a safety switch (A), first bring the safety switch towards
yourself then push simultaneously the on/off switch and de appliance will start. By pushing the
on/off switch again the appliance will stop.
• Attention! Do never touch the blade, the blade is very sharp and can injure you severely.
• Slide the cradle slowly to the right against the rotating blade. Capture the sliced food at the
back of the device.
• Attention! Never use the device without the holder, you can seriously injure.
• When turning of the device the blade remains turning for a while, do not touch the knife.
• After 10 minutes of continuous use, turn off the device and allow it to cool down, to prevent
overheating of the engine.

CLEANING AND MAINTENANCE

Unplug the appliance and allow it to cool down. Use a soft, slightly damp cloth to wipe appliance
surfaces. Do not allow water or any other liquid to get into the unit.
Remove the cutting blade
• Before removing the blades, disconnect the power plug.
• Attention! Never touch the edges of the blades! Make sure the removed cutting knife cannot
roll off the table! Keep children away!
• For removing the cuttingblade. Push the 'push button' in the middle of the cutting blade, a
latch will come out, turn the latch clockwise to unlock the cutting blade.
• Now you can clean the blade in soapy water, the blade is also dishwasher safe.
• For placing the cutting blade back in position. Make sure the tabs on the blade will match the
recesses in the appliance and put on the blade, lock the blade by turning the latch counter-
clockwise.
Cleaning the leading rod and craddle
For disassemble the leading rod and craddle. At the right side of the leading rod you will find
an hatch, slide this hatch to the right now you can take out the leading rod and you will be able
to clean these parts.
GUIDELINES FOR PROTECTION OF THE ENVIRONMENT
This appliance should not be put into the domestic garbage at the end of its durability,
but must be offered at a central point for the recycling of electric and electronic
domestic appliances. This symbol on the appliance, instruction manual and packaging
puts your attention to this important issue. The materials used in this appliance can be
recycled. By recycling of used domestic appliances you contribute an important push to the
protection of our environment. Ask your local authorities for information regarding the point
of recollection.
KMS 8302 User Manual
3