jbc DR560-A Manual De Instrucciones página 3

Connection
Tip
Ref. C560003
Desoldering process
Use a tip with a larger diameter than the pad to achieve maximum aspiration and thermal efficiency.
1. Placing
Place the tip with the
component terminal in
the hole.
After pressing the desoldering key there is a slight delay until the self-contained vacuum pump
stops. This makes sure that the vacuum circuit is completely empty. If any solder remains are left
on a terminal after desoldering it, resolder it with fresh solder and repeat the desoldering operation.
Desoldering Iron
Ref. DR560-A
to stand
to desoldering module
2. Rotating
When the solder liquefies,
gently rotate the tip so
that the compo nent
terminal can be lifted off.
w w w.jbctools.com
Suction Filter
Ref. 0821830
Supplied with desoldering module
3. Aspirating
Press the vacuum pump
button long enough to
remove the solder.
3