Operating Instructions; Dc Voltage Measurement; Ac Current Measurement; Resistance Measurement - GRUPO temper KOBAN KP 2600 Manual Del Usuario

Operating instructions

DC voltage measurement

1. Insert the black and red test leads
into the COM and VΩHz input
terminals respectively.
2. Set rotary switch at desired V
position. Select the desired DC
voltage range, or set automatic
range.
3. When the magnitude of voltage to
be measured is unknown, always
start with the highest range.
4. Connect the test lead tips in
parallel with the circuit to be
measured. Be careful not to touch
any electrical conductors.
5. The polarity of the red lead
connection will be indicated along
with the voltage value.
6. Read the measure result directly
from the display.
DC voltage measurement
1. Insert the black and red test leads
into the COM and VΩHz input
terminals respectively.
2. Set rotary switch at desired V~
position. Select the desired AC
voltage range, or set automatic
range.
3. When the magnitude of voltage to
be measured is unknown, always
start with the highest range.
4. Connect the test lead tips in
parallel with the circuit to be
www.grupotemper.com
Open jaw digit electrical tester
measured. Be careful not to touch
any electrical conductors.
5. Read the measure result directly
from the display.

AC current measurement

1. Set the rotary switch at A~
position.
2. To clamp one conductor in
Transformer jaws only, making
sure that the jaw is around the
conductor.
3. Read the measure result directly
from the display.

Resistance measurement

1. Insert the black and red test leads
into the COM and VΩHz input
terminals respectively.
2. Set rotary switch at desired
Ω position.
3. Push F.FUNC. button to select Ω.
4. If the resistance being measured
exceeds the maximum value of the
range selected or the input is not
connected, an overrange indication
"OL" will be display and the
higher range has to be selected.
5. Read the measure result directly
from the display.
Instructions manual |
KP 2600
19