HAMPTON BAY 7134-01 Guía De Uso Y Cuidado página 7

Installation - New Construction (continued)
4
Connect house and fan wires
 Pull the wire through the hole and into the junction box (not
included). Using a quick connector, secure 120 VAC house
wiring from the wall switch to the fan as shown in the wiring
diagram on page 3. 14AWG is the smallest conductor that
shall be used for branch-circuit wiring.
CAUTION: If the electrical wires do not match the colors listed,
you must determine what each house wire represents before
connecting. You may need to consult an electrical contractor to
determine safely.
 Push the wires back through the hole. Reattach the wiring box
cover.
5
Install the duct
 Install a circular 4 in. duct (not included) and secure it with
duct tape or clamps (neither included).
 Finish ceiling work. The ceiling hole should be aligned with
the edge of the fan housing.
6
Install the grille
 Pinch the mounting springs on the grille (B) and insert them into
the narrow rectangular slots inside the fan. Push the grille (B)
up toward the ceiling.
 Turn on electricity at the breaker box after finishing installation.
House
wires
4 in. duct
B
7
Please contact 1-855-HD-HAMPTON for further assistance.
Quick
connector
Product
wires
Duct tape
or clamp
HAMPTONBAY.COM
Ceiling