HAMPTON BAY 7134-01 Guía De Uso Y Cuidado página 9

Installation - Existing Construction (continued)
4
Remove the fan motor assembly
 Remove the three screws (1) that hold the fan motor assembly
in place. Remove the fan motor assembly from the fan housing.
Unplug the fan power unit.
5
Remove the wiring box knockout
 Remove the wiring box cover from the fan housing. Remove
the wiring knockout from the wiring box cover with a flathead
screwdriver (not included).
6
Connect house and fan wires
 Pull the wire through the hole and into the junction box (not
included). Using a quick connector, secure 120 VAC house
wiring from the wall switch to the fan as shown in the wiring
diagram on page 3. 14AWG is the smallest conductor that
shall be used for branch-circuit wiring.
CAUTION: If the electrical wires do not match the colors listed,
you must determine what each house wire represents before
connecting. You may need to consult an electrical contractor to
determine safely.
 Push the wires back through the hole. Reattach the wiring box
cover.
7
Install the duct
 Install a circular 4 in. duct (not included) and secure it with
duct tape or clamps (neither included).
 Finish ceiling work. The ceiling hole should be aligned with
the edge of the fan housing.
1
House
wires
4 in. duct
9
Please contact 1-855-HD-HAMPTON for further assistance.
Quick
connector
Pr oduct
wire s
Duct tape
or clamp
HAMPTONBAY.COM
Ceiling