Spanset Joker ASH 1t Borrador De Las Instrucciones página 16

The joker hook can also be used for extending and connecting
round slings
sling in the hook base does not pose a risk.
4 Inspection, maintenance, repair and end of use
Joker hooks must be checked for defects before each use. If you
detect defects, the joker hooks must be set aside.An authorized
person must perform the check according to the employer's specified
inspection interval, but at least once per year. Depending on the usage
and operational conditions, interim inspections may also be necessary.
The inspections must be documented according to BGR 500. Additio-
nally, all metallic fittings must undergo crack inspection at least once
every three years. The inspection must be done according to EN 10228
Part 1 (Magnetic powder testing - "fluxes") or Part 2 (Penetration Test).
After first use, an authorized person should make special inspections
after damage or special incidents that may affect the load capacity.
An exceptional check is to be carried out by a suitably qualified person
following damage or a special occurrence which may affect the
carrying capacity.
Speed up and simplify documentation of sling inspections. With
IDXpert
®
can find more information at our homepage: www.spanset.de.
The joker hook must no longer be used if you discover one of the
following defects:
- Damage from aggressive substances, such as acids or lye
- The contact surfaces to the sling are damaged or show signs of
wear, such as notches
- Hook base or hook head is worn by more than 5%] of the cross
section
- The safety flap is damaged, sticks or stays open
- The hook is bent or shows corrosion
- There are cracks or crush points
- The hook shows signs of major heat damage
Page
EN
14
. Tests have shown that the condition of the
10
, SpanSet offers the right software and hardware. You