Installation And Connection; Electrical Connection - Nice Patio1515 Instrucciones Y Advertencias Para La Instalación Y El Uso

4 1 INSTALLATION AND CONNECTION

WARNING
Damage to electric cables from to crushing or a tensile
load.
– All electric cables must be laid in such a way as
to avoid the risk of crushing and exposure to ten-
sile loads.
1) Fasten the device only by the fastening elements provided for this purpose. These
are located at the end of the housing and on the piston rod (see Fig. 1).
2) Connect the device to the electrical supply.

4 2 ELECTRICAL CONNECTION

WARNING
Damage to the device due to faulty electrical connection.
– The device must be operated with the correct
connection voltage (see type plate).
WARNING
Damage to the device from the use of a non-fitting or un-
suitable drive control unit.
– The control unit must support all the options at-
tached to the device.
– Connect all the marked cable conductors.
– Insulate unmarked cores/cables.
WARNING
Damage or destruction of the device due to faulty electri-
cal connection.
– The device must not be operated without an
overcurrent shut-off.
– The device must be shut off by an overcurrent
shut-off when it reaches the limit positions. The
overcurrent shut-off is optionally available as an
internal or external model.
– The customer-provided power supply must be
capable of making at least the minimum amount
of current available to each device (see section
4.2.2). If this current is not supplied, the device
cannot be shut off when it reaches the limit po-
sitions.
– If a configuration of the device without electron-
ics has been selected, the overcurrent shut-off
must be implemented externally by the customer.
WARNING
Damage or destruction of the device through ingress of
moisture in the connection cables.
– For devices with protection type IP 65, the cus-
tomer-provided connection of the cable ends or
connectors must also have IP 65 protection.
No circuit diagrams are listed below on account of the multitude of
configuration possibilities.
The device must be connected in accordance with the circuit diagram
included with the delivery.
Please refer to the following pages or the circuit diagram enclosed
with the delivery for connection of the option selected by you.
ENGLISH – 11