Maintenance And Cleaning - Mestra R-100136 Instrucciones De Uso

MAINTENANCE AND CLEANING

In order to ensure an optimum performance and reliability of the unit, we recommend the following:
Dry the tank and unit with a towel. Do not wash the unit completely with water to prevent the risk of shock.

Do not load the tank excessively; it could reduce the efficacy of the bath and damage the unit.

 Do not put very heavy or large objects in the bottom of the tank.
 Use chemical cleaning products compatible with the objects to be treated. Avoid corrosive solvents.
When items (especially valuable items) are being cleaned for the first time, carry out a trial run first with

just one item. Ask the manufacturer what cleaning solution is recommended.
During normal operation the bath and the base of the machine can heat up considerably. Temperatures up

to 70/80 ºC are completely normal, and can be reached after a long and continuous operation with the lid
on. If you wish to reduce the temperature, remove the lid and let the machine rest for a few minutes before
starting a new cycle.
 After using the unit, clean the tank and the external body with a damp cloth. Always unplug the unit before
cleaning it.
Keep the machine in a cool and dry place

PRECAUTIONS
IMPORTANT- The input
volts. Therefore, it is very important to observe the following Safety Regulations:
1) Do not open the lid when the power cord is connected to the power supply.
2) Do not spill water or any other conducting fluid over the unit's housing.
3) Always connect the unit to grounded power outlets.
 Connect the unit to a grounded 230 V, 50/60 Hz power outlet.
 Do not use inflammable solvents as cleaning solutions.
 Keep the unit unplugged before filling it. Do not fill the tank above the max. mark. Do not start up the unit
when the water level is below the min. mark.
 Do not allow children or unskilled people to handle the unit.
Do not turno n the unit without water in the tank.
Even though the unit is designed with multiple protections, if it is turned on for over 30
seconds without water in the tank, it may damage the unit or severetly reduce the life of
the unit. If heating over 3 minutes, it will damage the heater.
This unit is equipped with a thermal cutoff. If the cleaning function is turned on without
water in the tank, the temperature will rise continuously. The thermal cutoff will be
actuated after approximately 15 minutes respectively to ensure safety. The unit will be
disabled until it's repaired.
Do not run the unit for extended time or continuously.
The unit is designed with overheat protection. In the unit has been running for 45
minutes, it is recommended to stop the unit for about 20 minutes to prolong the life of
the unit.
Do not keep water in the cleaning tank for a long time.
Alter Cleaning is completed, open the drainage valve to drain the dirty water. Clan and
wipe the tank dry.
Do not spray water over the housing and keyboard.
Use a towel to wipe and dry the tank and the housing.
Do not expose the unit under direct sunshine for a long time.
Keep the unit in a dry, cool and ventilated area.
voltage
of the Ultrasonic Bath transducers can reach hundreds of
11