Cleaning Solutions; Technical Specifications - Mestra R-100136 Instrucciones De Uso

 Never submerge the unit in any liquid to clean it.
 Ultrasonic cleaning is not suitable for organic pearls.
 Do not open the unit while it is connected to the power supply.
 The machine lid may be hot after a cycle. Proceed with caution when removing it.
 If you are not sure of the effects of the cleaning solution on a given type of item, carry out a previous test
with a single item.
 Do not attempt to remove any screw or panel. The user does not need to manipulate anything inside.
 To prevent electric shock, never touch the power cord or socket with wet hands.
 Never operate the unit if the plug or the power cord is damaged. If the unit does not work properly, is
damaged or has fallen into the water, refer it to a technical service for examination and repair.
 Do not touch the unit if it has fallen into the water. Unplug it immediately.
 Use the unit properly according to the user's guide. Do not use accessories not recommended by the
manufacturer.
 The unit should never be left unattended when it is plugged.
 Do not operate the unit next to heat sources such as radiators.
 Install the unit on a dry and flat surface.

CLEANING SOLUTIONS

Cleaning solutions can be classified into two types: those with water as the basic element and cleaning
solution, and solvents.
The most common cleaning method is with water, as it has an acceptable capacity to dissolve inorganic
substances. However, it is extremely limited in dissolving organic substances. For this type of compound,
water is a good medium for the dispersion of waste particles, and a good support for specific detergents which
dissolve organic substances.
In most cases a mixture of water and domestic washing up liquid can be used as a cleaning solution.
Nevertheless, when the quantity or nature of dirt is resistant to this type of cleaning solutions, specific solvents
for ultrasonic baths have to be used. Under no circumstances should inflammable solvents or
environmentally unfriendly products be used.
PRINCIPLES OF ULTRASONC CLEANING
Millions of tiny air bubbles are
generated within liquid by
high frequency vibration.

TECHNICAL SPECIFICATIONS

Power supply:
Power:
Frequency:
Outside dimensions:
Tank dimensions:
Tank capacity:
Max. item length:
Tank material:
Timer:
Weight:

The air bubbles burst when in
contact with object.
230 V, 50 Hz
300 W
35 kHz
515 x 305 x 240 mm
323 x 205 x 99 mm
6 L
min: 3.35 L / max: 5 L
340 mm
Stainless steel
1 - 30 minutes
7.5 kg

The impact dislodges the debris to
achieve the cleaning effect.