DeWalt D28111S Manual De Instrucciones página 9

All manuals and user guides at all-guides.com
3. Press the guard down and rotate it to the required position.
4. Securely tighten the screw (H).
5. To remove the guard, slacken the screw.
FIG. 2
H
G
Fitting and Removing a Grinding or
Cutting Disc (Fig. 3A, 3B)
1. Place the tool on a table, guard up.
2. Fit the inner flange (I) correctly onto the spindle (J) (fig. 3A).
3. Place the disc (K) on the flange (I). When fitting a disc with a
raised center, make sure that the raised center (L) is facing the
flange (I).
4. Screw the outer flange (M) onto the spindle (J) (fig. 3B):
– the ring on the flange (M) must face towards the disc when
fitting a grinding disc (K);
FIG. 3A
M
L
C
F
K
I
G
J
C
– the ring on the flange (M) must face away from the disc when
fitting a cutting disc (C).
5. Press the spindle lock (C) and rotate the spindle (J) until it locks
in position.
6. Tighten the flange (M) with the two-pin spanner supplied.
7. Release the spindle lock.
8. To remove the disc, loosen the flange (M) with the two-pin
spanner.
WARNING: Do not use a damaged disc.
9
FIG. 3B
M
K
I
J
A
M
K
I
J
B