miniland baby 1.4 Manual Del Usuario página 19

Your Baby Monitor is supplied with 2 x AAA, 1.2V, 600mAh Ni-MH
rechargeable batteries for the parent unit. We recommend the use of the
batteries in the parent unit to be able to monitor to the baby unit from any
location. Reconnect the parent unit to the adaptor whenever possible to
keep the battery charged up.
Installing the batteries:
Connection to power supply:
1. Replace the battery cover, and then the belt clip.
2. Connect the adaptor lead to the adaptor connector socket.
3. Plug the adaptor as specified to the power voltage supply on the unit, then
switch on the mains power.
Baby unit
The baby unit of this baby monitor is designed to be powered by either batteries or
the provided AC/DC adaptor. The batteries are for backing up the baby unit during
a power failure. It is therefore recommended that you insert non-rechargeable
batteries in the baby unit.
Installing the batteries, main steps:
Connection to power supply, main steps:
1. Locate the connector socket at the left side of the baby unit.
2. Connect the adapter lead to the adaptor connector socket. Use only the supplied
adaptor.
3. Plug the mains adapter as specified to the power voltage supply on the unit, then
switch on the mains power.
1. Remove the belt clip by rotating the belt
clip 90 degree anti-clockwise and then pull
the belt clip out.
2. Remove the battery cover.
3. Insert 2 AAA rechargeable batteries by
following the marking polarities inside the
battery compartment.
1. Remove the battery cover.
2. Insert 3 AAA alkaline batteries by following
the marking polarities inside the battery
compartment.
3. Replace the battery cover.