Porter Cable 340 Manual De Instrucciones página 11

3. Open second paper clamp (as
described in Step 1).
4. Stretch the sandpaper tight over
the pad, position the loose end
under the second paper clamp,
and close paper clamp.
5. Punch holes in paper (for dust
extraction), as instructed in
"PAPER PUNCH" section of this
manual.
PAPER PUNCH
A Paper Punch is provided with
Model 340 Sander. The punch is used
to make eight holes through the
abrasive. These holes allow the
sanding dust to be extracted directly
through the pad. The punch can be
mounted to a workbench or wall
using four No. 8, flat head, screws
(see Fig. 5). To use the punch:
DISCONNECT TOOL FROM POWER SOURCE.
1. Install the abrasive to the sander as described in the "ATTACHING
STIKIT™ ABRASIVE" section, or the "ATTACHING CONVENTIONAL
ABRASIVE" section of this manual.
2. Position the sander to the punch (see Fig. 6), aligning the sander pad
with the two corner guides on the punch. Push sander onto the punch
until seated (see Fig. 7).
3. Remove sander from punch.
Fig. 6
11
Fig. 4
Fig. 5
Fig. 7