Porter Cable 340 Manual De Instrucciones página 13

A
Tap container lightly to remove
compacted dust. DO NOT WASH
CONTAINER. Dry compressed air
may be used to blow out container.
ACCESSORY PADS
Model 340 is supplied with a Standard Profile, PSA (Pressure Sensitive
Adhesive) Pad. This pad and some special purpose pads are available to fit
this machine. To install one of these accessory pads:
DISCONNECT TOOL FROM POWER SOURCE.
1. Remove abrasive from sander.
2. Use a T20 Torx screwdriver to
remove the four pad retaining
screws (Fig. 14), and lift the foam
pad (and its aluminum backing
plate), off the sander.
3. Position the accessory pad to the
sander and attach with the four
screws from Step 2.
Fig. 11
Wear ANSI Z87.1 safety glasses while using
compressed air.
A
Fig. 12
Fig. 13
Fig. 14
13
B
A
B