Important Safety Instructions - Fellowes POWERSHRED 72Ct Manual Del Usuario

Ocultar thumbs Ver también para POWERSHRED 72Ct:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 6
A.
B.
C.
D.
CAPABILITIES
Will shred: Paper, credit cards, staples, paper clips, CD/DVDs and junk mail
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper,
cardboard, laminates, file folders, X-rays or plastic other than noted above
Paper shred size:
Cross-Cut ......................................................................................................4mm x 38mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
to off or unplug when not in use.
openings. If object enters top opening, switch to Reverse (R) to back out object.
products on or near shredder. Do not use canned air on shredder.
Do not place near or over heat source or water.
BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly after each
pass to clear entry. Continuous operation
beyond 20 minutes will trigger 40-minute
cool down period.
2
E.
F.
KEY
A. Paper entry
G
B. CD/Credit card
H.
safety flap
C. Pull-out Bin
PAPER,
CARD or CD
1
2
Plug in and put
Set to Auto-On (I)
disconnect power
switch in ON (I) position
D. Window
E. Disconnect power switch
1. OFF
2. ON
F. See safety instructions
G. Handle
Maximum:
Sheets per pass ........................................................................................................... 12*
Cards per pass ............................................................................................................... 1*
Paper entry width .................................................................................................. 240mm
* A4 (70g), paper at 220-240V, 50/60 Hz, 2.2Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 800 sheets;
25 credit cards; 10 CDs.
12 sheets per pass.
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
voltage and amperage designated on the label. The grounded outlet or socket
transformers, or extension cords should not be used with this product.
4
3
or
Feed paper straight
To shred CDs or credit
into paper entry
cards rotate safety flap
and release
into place
ENGLISH
Model 72Ct
H. Control Switch and Indicator lights
R 1. Reverse
O 2. OFF
I
3. Auto-On (green)
4. Turbo Jam Release™ (red)
5. Door Open (red)
6. Overheat (red)
( )
5
6
Hold card/CD at
When finished
edge, feed into
shredding set to
card/CD flap entry
OFF (O)
and release

Publicidad

Tabla de contenido
loading

Tabla de contenido