Tabla de contenido
Publicidad
8.
Attach upper elevator tubes (28) to backboard brackets (25) using spacers (29), bolt (30), and
nut (32) as shown.
29
30
Support pole on sawhorse. Attach upper and lower
9.
elevator tubes (28) to top pole section (4) using bolts (30)
and nuts (32) as shown. Attach pole cap (38) as shown.
WARNING!
TWO PEOPLE REQUIRED
FOR THIS PROCEDURE.
FAILURE TO FOLLOW
THIS WARNING COULD
RESULT IN SERIOUS
INJURY AND/OR
PROPERTY DAMAGE.
29
32
25
28
Test fit bolts into
holes of backboard
brackets (29) and
carefully rock them
in a circular motion
to ream out paint
from holes if
necessary.
28
28
28
5
IMPORTANT!
32
21
IMPORTANT!
Test fit bolts into
holes of backboard
brackets (29) and
carefully rock them
in a circular motion
to ream out paint
from holes if
necessary.
WARNING!
TWO PEOPLE REQUIRED
FOR THIS PROCEDURE.
FAILURE TO FOLLOW THIS
WARNING COULD RESULT IN
SERIOUS INJURY AND/OR
PROPERTY DAMAGE.
32
32
28
28
28
28
32
04/06
38
ID# M7301241
Publicidad
Tabla de contenido
