Setting The Alarm - Philips HF3476 Manual Del Usuario

menu functions of middle selection wheel (sEt)
Below you find a description of all functions that can be set in the menu. These functions appear in
the menu in the following order:
- Clock time
- Alarm time
- Alarm sound
Sleep timer You can use the sleep timer when you want the radio and/or lamp to stay on for a set
-
period of time (15 minutes to 2 hours) before you go to sleep. You can switch off the sleep timer
again by setting the sleep timer period to 00:00 or by switching off the radio and/or lamp.
- Display brightness You can choose a display brightness between 1 and 4.
You can operate the function selection wheels in the following way:
1 Press the middle selection wheel (SET) to enter the menu.
 Turn the middle selection wheel (SET) to select a function.
 Press the middle selection wheel (SET) to enter this function.
 Turn the middle selection wheel (SET) to select a setting.
5 Press the middle selection wheel (SET) to confirm.
radio/volume
1 To switch on the radio, press the bottom selection wheel. (Fig. 11)
 To select the desired radio frequency, turn the middle selection wheel (SET) (Fig. 1).
Tip: To scan radio frequencies automatically, press and hold the middle selection wheel (SET) for approx.
2 seconds.
 To switch off the radio, press the bottom selection wheel again.
volume
1 To set the volume turn the bottom selection wheel to select the volume level you prefer.
You can choose a volume level between 1 and 20.
Note: The volume level you have selected is automatically set as the volume level for the alarm as well.

setting the alarm

When you set the alarm, you choose an alarm time and the type of sound you want to wake up to.
The alarm is set when the alarm symbol is visible on the display. The light intensity slowly increases
to the selected level during the last 30 minutes before the set alarm time. The sound slowly
increases in 90 seconds to the selected level after the set alarm time.
Note: You can set the light intensity or alarm volume by turning the top or bottom selection wheel
respectively. If you do not want to wake up to the lamp or to a sound, select a light intensity or volume
level of 0. See section 'Using the lamp' and 'Radio/Volume'.
1 Push the control lever down to the middle position to switch the alarm on. (Fig. 1)
The hour indication flashes (Fig. 14).
,
To adjust the time, follow steps  to 5. If the alarm time is correct, just wait for a few
,
seconds.
 Turn the middle selection wheel (SET) to select the hour.
Note: You can only do this when the hour indication flashes. If this is not the case, push the control lever
up and down again to enter the alarm time mode. You can also set the alarm time in the menu (see
section 'Menu functions of middle selection wheel (SET)' above).
EnglisH
9