Attach Rear Wheels - Unión De Las Ruedas Traseras - Kolcraft tiny steps Manual De Usario

Ocultar thumbs Ver también para tiny steps:
Tabla de contenido

Publicidad

3
Tabs
Lengüetas
4
Lengüeta
Consumer Service: 1.800.453.7673
www.kolcraft.com
Grooves
Ranuras
Attach Rear Wheels - Unión de las ruedas traseras
Tab
3
Underneath the tray, pull tabs and align into grooves.
Abajo de la bandeja, estire las lengüetas y alinée en las
ranuras.
4
Snap the back of the seat pad around the rear of the seat
ring.
Coloca el trasero de el cojín del asiento alrededor del trasero
de el anillo del asiento.
Test: Push down hard on seating area of seat pad to make
sure seat is securely in place.
Prueba: Empuje en el medio del cojín para asegurarse de
que está en su sitio.
CAUTION: Do not use walker if all tabs are not secured
properly, otherwise child may fall through walker.
PRECAUCIÓN: No utilice la andadera si todas las lengüetas
no están aseguradas adecuadamente. En caso contrario el
niño podría caerse de la andadera.
1
Flip base over to expose underside. Locate rear wheel
opening in base of the walker.
Voltée la base para exponer la parte de abajo. Localice la
abertura de la rueda trasera en la base de la andadera.
2
Align holes of wheel with corresponding axle holes on the
base of the walker. Plastic tab may need to be pushed to
the side to expose the axle hole. The stem of the wheel
should be facing the inside of the base.
Alinee los agujeros de las ruedas con los agujeros del eje
correspondientes en la base de la andadera. Puede que
sea necesario empujar la pestaña de plástico para que se
vea el agujero del eje. El tubo de la rueda debe de estar
opuesta adentro de el base.
3
Slide metal axle into holes from the inside towards the
outside of the base until the head of the axle passes the
plastic tab and the tab is able to hold the axle in place.
Deslice hacia los agujeros del eje de metal desde el interior
hacia el exterior de la base hasta que la cabesa del eje pase
la lengüeta de plástico y la lengüeta es capaz de mantener
el eje en su lugar.
4
Repeat for other wheel.
Repita el proceso en la otra rueda.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido