Shock Sensor - Cooper 735r Manual Del Usuario

1. Place the transmitter in programming mode.
2. Operate the roller shutter sensor for the required number of open/close events. (Make
sure that all the open/close events occur within 20 seconds.)
3. Leave programming mode.
The transmitter will now signal an alarm condition after the programmed number of open/
close events.

Shock Sensor

When using the 735r with a shock sensor you can program the minimum level of shocks
that the transmitter will respond to.
1. Place the transmitter in programming mode.
2. Vibrate the shock sensor with smallest level of force that you wish the transmitter
to respond to (strike the wall or door on which the sensor is mounted). Activate the
sensor repeatedly four or five times.
3. Leave programming mode.
The transmitter will now ignore any shocks smaller than the average of those you used
during programming.
14