Publicidad
Assembly
!
5A
5F
5B
K7
Ref.
Description
K1
Pump Assembly (K1a OR K1b)
K2
1.5" Discharge Hose Assembly (One end connects to pump,
other end connects to nozzle then RV dump station.)
K7
3" RV Inlet Hose (One end connects to pump, other end con-
nects to RV sewer outlet.)
Install Pump
Choose the adapter bracket position that best suits your
NOTICE
RV layout. Refer to
Prepare
■ Flush all debris from holding tanks.
■ Close all dump valves
■ Verify that installed unit will not interfere with the operation
of the gray and black water RV dump valve handles
Install
1.
Attach the adapter bracket with installation screws (4x).
(K1a)
Refer to
.
2.
Attach the base bracket with installation screws (2x). Refer
(K1b)
to
.
Position the pump
NOTICE
AVISO
CAUTION
AVIS
!
ment floor or wall making sure that it is lower than
the sewer outlet
sewer outlet.
3.
Fasten the base bracket to the mounting surface using ¼"
fasteners (not provided).
4.
Connect the bayonet adapter to the RV's sewer outlet.
(K7)
5.
Verify the inlet hose
Avoid kinks, traps, or excessive distance in the inlet hose.
NOTICE
AVISO
CAUTION
AVIS
!
Trim the hose, if necessary. Do not overtighten the hose
clamp when adjusting the hose length, as it may damage
the hose. Refer to FIG. 5.
Sani-Con Model 600 - Permanent Storage Mount
5D
5A
5E
(K1b)
.
(5B)
.
(K1)
and bracket on the compart-
(5F)
and the inlet hose reaches the
is positioned properly.
Fig. 5
K2
K1
Ref.
Description
5A
Plumbing (Hard or flexible pipe) to discharge hose
5B
Gate Valves (black, gray, manual over-ride); number of valves
vary according to each coach setup
5D
RV Compartment
5E
RV Sidewall
5F
RV Sewer Outlet
(5B)
.
6
i
K1a
i
K1b
www.thetford.com
Publicidad
Capítulos
Solución de problemas
