Controlling The Car - Funtek DT12 Manual De Usuario

CHARGER / BATTERY PACK / CIRCUIT BOARD PRECAUTIONS
1. To prevent the lithium-ion battery pack from being charged over -voltage, which could lead to damage
or explosion, the charger uses a voltage limit protection device. And to maintain the battery pack's
charging capacity and performance, we suggest not to charge it continuously for more than 24 hours.
2. The battery uses a low voltage and power over-discharge protection device. When the battery is over-
discharged, a re-charged is required to active the battery again. It is recommended that you remove
the battery and turn the switch to OFF position when the car is not being used.
3. The circuit board uses a overheating protection function. When the circuit board is overheated, the car
will be disabled (not moving forward/backward) for 3-6 seconds before being restored.

CONTROLLING THE CAR

1. Place the steering wheel on the transmitter
2. Pair the frequency of the car and the transmitter
(a) When being paired for the first time, both the car and the transmitter have
to be turned on within 3 seconds to pair the frequency. (During pairing,the
LEDs on the car and the transmitter will fiash; they will turn solid once
pairing is successful)
(b) When pairing the frequency,please don't let anything touch accelera-
tor,ensure that the accelerator position does not appear deviation.
c) In case pairing is not successful,please turn off both the car and the
transmitter, and repeat the pairing process above.
Power Power
Light Switch
TRANSMITTER OPERATION AND MINITRIM
1. STEERING
WHEEL OPERATION
3. STEERING L/R ADJUSTER: RESTORE STRAIGHT DRIVING WHEN THE CAR CANNOT MOVE FORWARD IN A STRAIGHT LINE
Figure 11
When the car left driving, steering trim should be
adjusted clockwise (Figure 11).
NOTE: LED will flash when power is low on the car or the transmitter,
please recharge or replace the batteries before continuing.
Power
Figure 13
Switch
2. MINITRIM
OPERATION
- 4 -
When the chassis switch is turned on
and the front tyres are not staight, use
the steering trim to adjust the postition.
Figure 12
When the car right driving, steering trim should
be adjusted anticlockwise (Figure 12).