Remote Control Buttons; Turning Power On And Off - Brandt BTD-200BT Manual De Instrucciones

Remote control buttons

1
2
3
4
5
6
7
Remote l range
contro
Remote sensor
Distance: Within approximately
7 m directly in front.
30° 30°

TURNING POWER ON AND OFF

1. Place the unit on a flat stable surface.
2. Plug the unit into the mains socket.
• The unit will enter the standby state.
• The display will show "0:00" when you use the unit for the first time.
3. Press to turn on the power.
• The display will show "WELCOME" briefly.
4. To turn the power off, press
• The unit will enter the standby state.
To save power, the unit will enter the standby mode when the unit is idle for about 6 hours.
1. SOURCE
8
2. MUTE
9
3. MEM
10
11
4. CH-
5. Numeric buttons
6. BASS +/-
7. TREBLE +/-
12
8.
13
9. PAIR/
10. MO/ST
14
11. CH+
12. CLOCK
15
13. SLEEP
14. TUNING/
15. VOL +/-
• The remote control works within a distance
• To avoid interference, do not put any
again.
EN-3
/
of about 7 metres from the sensor and
within an angle of about 30 degrees from
the left and right sides.
objects in front of remote sensor.