Setting The Clock (Remote Control Only); Setting The Sleep Timer; Bluetooth Operations; Pairing Bluetooth Devices - Brandt BTD-200BT Manual De Instrucciones

SETTING THE CLOCK (REMOTE CONTROL ONLY)

1. In standby state, press and hold CLOCK until the hour digits are flashing on the display.
• The display will show "CLK".
2. While the hour digits are flashing, repeatedly press
• The minute digits will flash on the display.
3. While the minute digits are flashing, repeatedly press
4. Press CLOCK to confirm.
• "CLK" will disappear on the display.

SETTING THE SLEEP TIMER

The sleep timer is a countdown timer for switching the system to standby mode after a specified
time. The sleep timer can be set from 90 to 10 minutes in 10 minute steps.
1. Press to turn on the unit.
2. Select the desired source by repeatedly pressing SOURCE.
3. Press SLEEP on the remote control to set the sleep time (in minutes).
• "SLEEP" and "90" will be shown on the display. The unit will now play for 90 minutes.
4. To decrease the sleep time in steps of 10 minutes, repeatedly press SLEEP until the desired
sleep time is shown.
• The remaining sleep time can be checked by pressing SLEEP.
5. To cancel the sleep timer, press SLEEP until "OFF" appears on the display.
6. To switch off the unit before the sleep time has elapsed, press

BLUETOOTH OPERATIONS

By using the Bluetooth connection, you can listen to the sound from the Bluetooth audio device
from this unit wirelessly.

Pairing Bluetooth devices

• Turn on the Bluetooth function of the device and place the device near this unit.
• If this unit is already connected to a Bluetooth device, disconnect it.
1. In power on state, press SOURCE until "PAIRING" appears on the display.
• The Bluetooth indicator light will flash, indicating the unit is searching Bluetooth enabled
device to pair.
2. Select "BTD-200BT" from the Bluetooth device's Bluetooth menu.
• Note: If you are required to enter a PIN code, enter 0000. Certain devices may also
require you to approve the connection.
3. Once pairing is successful, the display will briefly show "CONNECT" and then show "BT" and
volume level.
• The Bluetooth indicator light will stop flashing.
4. Start play on the Bluetooth device.
• The effective operation range between the unit and the paired Bluetooth device is
approximately 10 metres in the open area.
• This unit can only be connected to one device at a time.
/ to set the hours.
or to set the minutes.
EN-4
.