Extremis MARINA PICNIC Manual Del Usuario página 5

6. Insert the tabletop end piece with the lips into the slots
from left to right. Fasten them using 5/6 M5 x 12
countersunk bolts. Repeat this operation on the other
side, this time from right to left.
8. Put the 2 bench profiles on the floor, with the slots
facing upwards, and make sure that the crosses are
facing the same way. Insert a spacer between the
profiles at +/- 40 cm from the end.
1
2
10. Position the benches on the bench connections and
fasten them using 4 M6 x 20 hexagon socket bolts per
leg per side. First screw bolts
them. Thereafter bolts
hexagon socket wrench no. 4.
1
2
, but do not tighten
1
. Now tighten all bolts with a
2
7. Now fasten the table leg assembly with the tabletop
connection to the profiles, each time at the intended
place, using 10/12 M6x20 hexagon socket bolts.
Remove the spacers and turn over the table.
9. Insert the bench end piece with the lips into the slots
from left to right. Fasten them using 2 M5 x 12
countersunk bolts per side. Repeat this operation on
the other side, this time from right to left. Remove the
spacers.
11. Level the table by screwing the adjustable feet in or
out and fasten the feet by turning the nut until it sits
against the leg.
english 5