Descargar Imprimir esta página

Assembly Marina Picnic; What You Need - Extremis MARINA PICNIC Manual Del Usuario

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43

ASSEMBLY MARINA PICNIC

WHAT YOU NEED

min. 2 people
no. 10 - 17 spanner
no. 3 - 4 hex key
+/- 60 min. (depending
on the length of the
table)
2. Slide the bench supports onto the table legs.
4. Now screw the adjustable feet into the legs. Repeat step
1 through 4 for each table leg assembly and put them
aside.
4
assembly marina picnic
1. Insert the table legs into the tabletop connection, aligning the 3 holes, and
use 12 M6x16 hexagon socket bolts and lock nuts to fasten them. First push
all the bolt shafts through the holes and make sure that the bolts are on the
outside. Then thread the nuts onto the shafts of the bolts and tighten them
firmly.
3. Slide the bench connections onto the table leg and the
bench support. First push 12 M6 x 16 hexagon socket
bolt shafts through the pre-drilled holes. Make sure
that the bolts are on the outside. Only then thread the
12 lock nuts onto the shafts of the bolts and tighten
them firmly!
5. Put the 5/6 tabletop profiles on the floor, with the slots
facing upwards, and make sure that the crosses are
facing the same way. Insert a spacer between each
profile at +/- 40 cm from the end.

Publicidad

Capítulos

loading