Assembly Floor Fastening - Extremis MARINA PICNIC Manual Del Usuario

ASSEMBLY FLOOR FASTENING

B
1. Mark the spot on the ground where you want to put the table. There are two anchor points per leg frame (see
diagram above).
L = distance between the legs
B = width of the leg frame
B
B (5 profiles) = 1100,50 mm
B (6 profiles) = 1245,50 mm
Attention! If the floor fastening set
was ordered later, it is likely that the
nuts are still in the legs.
6 assembly floor fastening
L
Drill the nuts out of the legs with
a ø12 drill. Now continue with the
next steps.
L
L = distance between the legs
2. Use an electric drill to drill 12 mm
diameter holes on the spots you
marked and insert a 12 x 60 plug
in each hole.
L