Fan Assembly. Pgs - Craftmade Ellington BEL52BNK3-NRG Manual Del Usuario

5. Fan Assembly.
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the 4.5-inch downrod provided to use
with an extended downrod (sold separately). [If
you wish to use the 4.5-inch downrod, please
proceed to instructions following the dotted line
below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
Locate canopy cover in one of the hardware
pack. Loosen yoke set screws and nuts at top of
motor housing and remove pin and clip from
motor housing yoke. Slide downrod through
canopy, canopy cover and yoke cover. [Note:
Canopy cover must be turned with shiny side
toward the motor.]
Thread electrical wires through downrod and
pull extra wire slack from the upper end of the
downrod.
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align
with holes in yoke--make sure wires do not get
twisted. Re-insert pin and clip that were
previously removed. Securely tighten yoke set
screws and nuts. Lower yoke cover to motor
housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common sense
and caution are necessary factors in the installation
and operation of this fan.
set screw
A
downrod
canopy
yoke cover
pin
page 4
stop pin
hanging ball
B
electrical wiring
canopy cover
yoke set screw
motor
housing
set screw
hole
clip