Light Kit Assembly - Craftmade Ellington BEL52BNK3-NRG Manual Del Usuario

9. Light Kit Assembly.

Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws.
Align slotted holes in center of switch
housing with loosened screws in motor plate,
allowing male plug from motor housing to
come through hole in middle of switch
housing. Twist switch housing to lock.
Re-insert screw that was previously removed
and securely tighten all 3 screws with Phillips
screwdriver.
Remove 1 screw from post located on
underside of switch housing and partially
loosen the other 2 screws.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter. Connect BLUE
(or BLACK) wire from switch housing to
BLACK wire from light kit fitter. Be sure molex
connections snap together securely. Connect
male plug from motor housing to female plug
from light kit fitter. Be sure that plugs connect
securely as well.
Align slotted holes in light kit fitter with
loosened screws in switch housing. Twist light
kit fitter to lock. Re-insert screw that was
previously removed and tighten all 3 screws
securely.
Install 2 compact fluorescent13 watt max.
bulbs, size GU24 (included).
Important: When replacing bulbs, please
allow bulb(s) and glass shade to cool down
before touching them.
Align grooves on glass shade with nodules on
inside of light kit fitter and push up gently on
glass shade. Twist glass shade to the RIGHT
(clockwise) until glass shade locks into place.
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
switch
housing
motor housing
molex
connections
bulb
Hg
LAMP CONTAINS MERCURY
Manage in accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow clean-up
procedures provided by contacts below.
www.epa.gov/cflcleanup
1-866-284-4010
page 7
motor housing
motor plate
male plug
TRANSMITTER
(front)
switch
housing
male plug
female plug
light kit fitter
glass shade