GE WSLP1500 Manual Del Propietario E Instalación página 15

WASHER CONNECTIONS - STATIONARY MODEL WSLS1500
WARNING:
unplugged.
FLUSH WATER LINES
1
Run some water from the hot and cold faucets
to flush the water lines and remove particles that
might clog up the water valve screens.
CONNECT TO WATER LINES
2
Connect the inlet hose ends to the HOT and COLD
water faucets tightly by hand, then tighten another
turn with pliers. Turn the water on and check for
2 3
leaks. Retighten if necessary.
CAREFULLY MOVE THE WASHER
3
TO ITS FINAL LOCATION
Installation Instructions
Make sure the washer is
CONNECT DRAIN HOSE
4
Form a U shape on the end of the drain hose with
the hose pointed toward the drain. Place the hose in
a laundry tub or stand pipe and secure it with a cable
tie (not included).
NOTE: If the drain hose is placed in a stand pipe
without forming a U shape, a siphoning action could
occur. There must be an air gap around the drain
hose. A snug hose fit can also cause a siphoning
action.
Cable Tie
PLUG THE POWER CORD INTO A
5
GROUNDED OUTLET
Ensure proper ground
exists before use
15
Cable Tie
Laundry Tub
Stand Pipe
Cable Tie