Du Pont WFRO60X-1 Serie Instrucciones De Instalación página 18

TASTES AND ODORS IN PRODUCT WATER
POSSIBLE CAUSE
Carbon Post Filter is exhausted.
There is foreign matter in the Holding Tank.
Product water and Drain water lines are
reversed.
Dissolved gases in feed water.
Increase in Product Water TDS.
LEAK FROM AIR GAP HOLE IN FAUCET
POSSIBLE CAUSE
Air Gap is clogged.
Drain line is clogged.
Drain flow rate is too high.
QUICK CONNECT FITTINGS LEAK
POSSIBLE CAUSE
Tubing is crimped or bent at connection.
Tubing is not cut squarely.
Tubing does not enter fitting at 90° angle -
not enough tubing.
O-ring inside fitting is damaged.
Collet inside wall is damaged.
WFRO60X-1
SOLUTION
Replace Filter with DuPont model number WFQTC30001.
Follow the clean, flush, and sanitizing procedures.
Replace all filters.
Correct plumbing according to installation instructions.
Pre-treat feed water to remove gasses.
See High TDS in Product Water Section.
SOLUTION
Remove faucet body from faucet base and disconnect air gap 1/4" tubing. Ensure there are no obstructions - clear them out.
Remove faucet body from faucet base and disconnect drain 3/8" tubing. Ensure the drain connector is properly aligned with the hole in the
drain pipe. Ensure there are no obstructions - clear them out.
Replace Flow Restrictor.
SOLUTION
Remove tubing, cut 1" off squarely - making sure to not crimp. Use a very sharp exacto or utility knife. It is not recommended to use side-
cutting or diagonal-cutting pliers. Wet the tubing end and insert 5/8" until fully inserted.
Remove tubing, cut 1" off squarely - making sure to not crimp. Use a very sharp exacto or utility knife. It is not recommended to use side-
cutting or diagonal-cutting pliers. Wet the tubing end and insert 5/8" until fully inserted.
Re-route tubing to allow it to enter fitting at a straight 90° angle. If not enough tubing to allow, remove tubing and use a longer piece.
Remove by pressing in the white collar while pulling the Plastic Tubing out with your other hand.
Replace O-ring by removing collet with small screwdriver. Be careful not to scratch the internal walls of the collet. Ensure new O-ring is
properly lubricated.
Replace collet by removing with small screwdriver. Be careful not to damage the O-ring.
18 V4.5E