Du Pont WFRO60X-1 Serie Instrucciones De Instalación página 9

STEP 6
Connect Tubing
Install 1/4" Plastic Tubing for Water Supply Line from Kitchen
Faucet Adapter to System Head Inlet
1
Determine the length of the 1/4" White Plastic tubing U that will be necessary to connect the RO System Head A Inlet
(labeled "INLET") to the Kitchen Faucet Adapter F. Make sure to allow enough Plastic Tubing to prevent kinking in the
line. Do not discard the remaining tubing for it will be used in Step 7.
2
Cut the 1/4" White Plastic Tubing U squarely on both ends with a utility knife, making sure not to crimp the Plastic Tubing
during cutting.
3
Wet one end of the 1/4" White Plastic Tubing U with water and push it into the Kitchen Faucet Adapter F approximately
5/8" until it stops.
NOTE: Do not bend or crimp 1/4" White Plastic Tubing when inserting.
4
Wet the other end of the 1/4" White Plastic Tubing U with water and push it into the RO System Head A Inlet
approximately 5/8" until it stops.
NOTE: The 1/4" Plastic Tubing does not need to be disconnected for general routine maintenance and
filter replacement. However, Plastic Tubing may be easily disconnected if necessary. Simply turn off the water supply to
the Filter System and press in the white collar around the fitting while pulling the Plastic Tubing out with the other hand.
Install 3/8" Plastic Tubing for Water Supply Line from System
Head Outlet to RO Faucet
5
Locate the 3/8" White Plastic Tubing S (see page 7 Step 2) attached to RO Faucet Body P (see page 7 illustration).
6
Determine the length necessary to connect to the RO System Head A Outlet (labeled "FAUCET").
7
Cut the tubing squarely with sharp utility or exacto knife.
8
Wet the end of the 3/8" White Plastic Tubing S with water and push it into the RO System Head A Outlet (labeled
"FAUCET") approximately 5/8", until it stops.
WFRO60X-1 9
3
F
4
A
INLET
U
A
TANK
FAUCET
8 S
6
V4.5E