Publicidad
SLIDING DOOR HARDWARE -
MINI CARRIER KITS FACE MOUNT
4
MOUNT ANTI-JUMP BUMPERS
• Attach anti-jump bumper to the top of the door on the inside
of each carrier within 2" of carrier using provided screws.
6
INSTALL FLOOR GUIDE
• Locate floor guide in the center of travel so that door is always contained by floor guide.
• Using floor guide as a template mark mounting hole locations.
• Drill pilot hole at least 1.18" (30mm) deep using a 5/16" (8mm) drill bit.
• Install 8mm anchors (K) and mount floor guide using provided screws (H).
5
PREPARE DOOR AND INSTALL
• Route bottom of door for floor guide using 1/4" (6.35mm) routing bit.
• Rotate anti-jump bumper away from backside of door.
• Hand door on rail by sliding on from the end. If space does not allow, then
with help from a partner, tip the bottom edge of door away from track and
place carriers on the rail. Swing door down into position.
• Rotate anti-jump bumper back into position.
#N310639 (0318)
Assembly
Instructions
7mm
20mm
Publicidad
