Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Front
Passenger side shown
Repeat for opposite side
Complete bracket installation by adjusting bracket
assembly so that the holes in support bracket line
up with the holes in the pinch weld. Use a washer
to shim the support bracket out from the pinch weld.
Insert a black flange bolt through the pinch weld,
washer and support bracket, and secure with flange
nut. Finger tighten hardware. Repeat bolt installation
for second hole of bracket.
5
Install running board to brackets using hardware
provided in board kit. Refer to board installation sheet
for specific instructions.
Tighten bracket hardware after board has been
installed.
Repeat installation for opposite side of vehicle.
Reinstall cladding.
Front
Passenger side shown
3
12
PAGE
OF
Rev B
Publicidad
Tabla de contenido
