Installation Steps - LUND 310045 Manual De Usario

Installation Steps

For vehicles with cladding, carefully remove the cladding
from the vehicle by squeezing the plastic fasteners and
pushing them through the hole .
Identify the mounting locations for each bracket by
looking under the vehicle and finding the three sets
of holes in the pinch weld.
Attach support bracket to channel bracket by
inserting black flange bolt through holes in
support bracket and channel bracket and
securing with flange nut. Finger tighten
hardware. Repeat until (6) assemblies have
been made.
2
Front
Passenger side shown
Repeat for opposite side
Begin bracket installation by inserting rivnut into
factory hex hole. Line up rivnut so that channel
bracket fits over it. Insert a flange bolt through
a washer and then thread into rivnut.
3
Front
Passenger side shown
2 12
PAGE OF
10419
Rev B