Viper Ttl Transmitter; Wireless Setting; Dcm (Digital Channel Matching); Viper Ttl Group Mode Setting - Hahnel MODUS 600RT Manual De Instrucciones

5
Wireless Settings

DCM (Digital Channel Matching)

1. DCM (Digital Channel Matching). Carry out the DCM
matching, see page 27
2. Set the Modus 600RT to 2.4GHz as Slave Unit - Group
A, see page 27
3. Press Viper <test>
Speedlight is triggered wirelessly

Viper TTL group Mode Setting

Press buttons
of each group to <TTL>, <M> manual & <blank> OFF.
Take a test photograph now and the Viper transmitter will
send a wireless signal to each Modus 600RT and to each
3rd Party Speedlight connected to a Viper TTL receiver.
The Speedlight will then be set automatically to the same
Viper TTL selected group mode setting.
• The Viper LCD
• A group is turned OFF if the LCD is not showing the group
• A group is in Manual mode when <M> is displayed next
to the group
• A group is in TTL mode when <TTL> is displayed next to
the group
• Each group
possible to use simultaneously different setting for each
group (e.g. Group
and Group
Group Power Control setting for
Manual and TTL FEC
From the Viper TTL transmitter you can adjust the power
level and the FEC of each group.
4. Press <SEL>
<B> and <C> will flash.
5. Press one button
you want to adjust the power. Now only the selected
group icon <A or B or C> will flash
6. Use the adjust dial to set the power output in <
mode and FEC in TTL mode
7. Press the <SEL> button to lock your selection
38
Wireless Flash
Photography:

Viper TTL Transmitter

08 button to confirm that Modus
A B C
or or
05
will show the setting of each group
A , B or C
A
may be in <M>, Group
C
turned OFF)
02 select button and all three icons <A>,
A or B
(2.4GHz) using
to change the MODE setting
is set independently and it is
or C to select which group
B
in <TTL>
>
M
Modus 600RT