osann NEO360 Manual De Instrucciones página 20

EN
Removing the belt systems
First press Strap adjuster. Then with the other hand, pull up the connection of shoulder strap
from the back of the Shell. (See below pictures) Remove the Strap from the connection of
shoulder strap and pull out the straps from front of the car seat. So the headrest continues to
upwards to meet the taller children.
Remove the two tongues of buckle from straps and insert to the buckle slot. Then together with
straps directly put into the place under the seat cover for store.
Isofix connectors
•
Push the red insertion aids through the slot in the
upholstery between backrest and seat and into the
Isofix brackets.
•
Make sure the flat side is facing down. This is not
necessary if the vehicle already has fixed insertion
aids.
•
Press both side Isofix connector buttons to extend
the Isofix connectors in length.
•
Insert the Isofix connectors into the insertion aids
and press until you hear them click into place.
•
The display on both sides only turns green when
the connections are made. Press the child car seat
against the backrest until it is secure.
Top-Tether
•
Take the top tether out of the pocket.
•
To release the top tether, press the grey adjustment
button with one hand and pull the side of the belt
anchor to the required length with the other hand.
•
To attach the Top-Tether, attach the anchor to the
attachment point on the car seat (pay attention
on top-tether routing for each group) and pull it
as tightly as possible. The indicator does not turn
green until the belt is locked.
- 20 -