User Maintenance - Andis TS-2 Instrucciones De Uso Y Cuidado

USER MAINTENANCE

If shaver is to remain unused for a long period of time, store in a safe, cool, dry
place. Do not wrap cord tightly around shaver. Do not hang the shaver by the
power cord. Other than the recommended maintenance described in this
manual, no other maintenance should be performed, except by Andis Company
or an Andis authorized service station. To contact Andis directly, please call our
Customer Support Team at 1-800-558-9441 or email us at support@andisco.com.
IMPORTANT: For best shaver performance and results, it is recommended
that you replace your shaver's foil assembly and cutters every six months.
TO REPLACE FOIL ASSEMBLY
1. Remove the foil assembly by pressing the round assembly lock button located
on the right side of the shaver. Grasp the foil assembly on both sides and
gently lift it off the shaver (Figure C).
2. Position the replacement foil assembly over the cutters. Be careful not to
damage the foils. Gently slide the foil assembly down until it snaps firmly into
place.
TO REPLACE CUTTERS
NOTE: Always replace the foil assembly when replacing the cutters.
1. To remove a cutter, grasp it on both sides and pull up (Figure D).
2. To replace a cutter, hold it on both sides and line up the small metal shaft on
its underside with the notch on the shaver drive and push down firmly until it
snaps into place.
3. Replace foil assembly.
CLEANING
Regular cleaning is necessary in order to maintain the optimal performance and
maximum comfort from your shaver. Do NOT run shaver, foil assembly or
cutters under water. Use only the small brush (included) to clean.
DRY CLEANING WITH BRUSH
1. Remove the foil assembly by pressing the round button located on the right
side of the unit. Grasp the foil assembly on both sides and gently lift it off of
shaver (Figure C).
2. Gently tap the base of the foil assembly on a flat surface so that the hairs
inside fall out. Do not remove the foils or they may be damaged accidentally.
3. Lightly brush the hairs out from the cutters. You can remove them from the
shaver if necessary. Blow out any remaining loose hairs.
4. Replace the cutters and foil assembly.
6