Positioning Detachable Blower (Power Head Assembly); Insert Hose - Craftsman 113.170660 El Manual Del Propietario

Ocultar thumbs Ver también para 113.170660:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SP6570 16 gallon detach
Positioning Detachable Blower
(Power Head Assembly)
1. Locate the detachable blower of your
Craftsman Wet/Dry Vac.
2. On top of the blower (opposite the
handle side of the blower); there is
molded plastic lead that is used to
assist assembling the unit. Position
the lead into the indented area above
the label.
3. Rotate the detachable blower down
until the travel of the unit stops.
4. Lightly press down on the carry handle
of the detachable blower until the
power head latch engages the blower.
The detachable blower is now latched
to the lid assembly.

Insert Hose

Insert the hose locking end of the "Pos-I-
Lock" hose into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac, press the release
button in the hose assembly and pull the
hose out of the vac inlet, as shown.
Your new Wet/Dry Vac is ready for use.
12/8/04
8:47 AM
Page 8
Detachable
Blower
Power
Head
Latch
8
Molded
Plastic
Lead
Indented
Area
PRESS &
PULL
Release
Button

Publicidad

Tabla de contenido
loading

Tabla de contenido