Blower Intake - Craftsman 113.170660 El Manual Del Propietario

SP6570 16 gallon detach
Operation (continued)
Blowing Port
Male-to-Male
Adapter
The wet/dry vac may also be used for
blowing using the seven foot hose sup-
plied with the wet/dry vac.
Install the male-to-male adapter in the
blowing port of the wet/dry vac.
Assemble the hose to the blowing port
and connect the blower nozzle to the
opposite end of the hose.
The unit is ready for blowing applications.
Maintenance

Blower Intake

WARNING:
To reduce the risk of
injury, unplug unit before cleaning
foam pad. Before using, intake shield,
pad holder, and pad must be in place.
After using the detachable blower of your
wet/dry vac, examine the bottom of the
blower for dust and debris. Check to see
if the intake to the blower has debris
stuck to the plastic vents and foam pad.
To clean the foam pad under the intake
shield of the detachable blower:
12/8/04 8:47 AM Page 12
Extension
Wand
Blowing
Nozzle
1. Remove the three screws holding the
intake shield.
2. Lift the intake shield off and set aside.
3. Lift the foam pad away from the
detached blower, the foam pad holder
will also lift away from the blower.
4. Remove the foam pad from the foam
pad holder and set the foam pad hold-
er to the side. Clean the foam pad in
warm soapy water or brush debris
away. Allow foam pad to dry.
5. Examine foam pad for reuse. If you
need to replace it, check the service
part section of this manual.
12
Blowing Port
Blowing
Nozzle
Blowing
Nozzle
Hose
Blowing
Port