c. Reinsert the screw into the handlebar
release lever, then hand tighten.
NOTE: Replacing the screw keeps the
handlebar release lever from coming
apart.
9. Remove the two screws securing the recline
strap to the stroller frame (Fig. 9).
10. Remove the 10 remaining fabric screws
holding the seat to the frame (Fig. 10).
11. Remove the seat from the stroller.
Installing the Seat
1. Lay the new seat in the stroller.
2. Starting at the bottom of the seat, install
the 10 fabric screws through the grommets
and attach the seat to the stroller frame
(Fig. 10).
3. Feed the recline strap over the top of the
handlebar from behind and install the two
screws securing the seat and recline strap
to the frame (Fig. 11).
4. Remove the screw from the handlebar
release lever, then install through the
canopy grommet and seat grommet back
into the handlebar (Fig. 12).
5. Zip the canopy onto the seat.
6. Turn the stroller over and re-attach the
black hook-and-loop tension strap to the
underside of the stroller (Fig. 13).
7. Replace the screws securing the stroller
harness straps to the frame (Fig. 14).
8. Starting at the center, route the ends of the
fold release cable through the loops toward
the frame, then install the screws (Fig. 15).
9. Replace the front two fabric screws and
nuts attaching the lowboy to the frame
(Fig. 16).
10. Replace the two Phillips screws in the
footwell (Fig. 17).
11. Replace the front wheel nose cover by
securing the three Phillips screws to the
stroller frame (Fig. 18).
12. Verify that the stroller is ready for use
by completely folding and unfolding the
stroller.
Pag e 2 o f 6
A: 02. 1 6
P045 2 9 6 0 0
BOB
Instructions / Instructions / Instrucciones
9
11
13
15
Footwell
(2 screws)
17
REVOLUTION
®
10
12
14
16
18
BOB Ge ar by B rita x, 4140 P lea sa nt Road , For t M ill, S C 29 70 8
Cons ume r S er v ice : 888.427. 48 29 or 7 04 . 40 9. 1 69 9
© 2016 Br itax Child Sa fety , In c. A ll rights res er ve d.
Strollers
®
Wheel Nose Cover
(3 screws)
w w w. B OB ge ar. c om