Cleaning Filters - BLACK&DECKER BDH2000FL Manual De Instrucciones

CLEANING FILTERS

Both the plastic pre-filter (17) and the pleated filter (18)
are re-usable and should be cleaned regularly.
• Pull the door latch (8) and open the transparent door
(6) 180 degrees.
• Remove the pre-filter (17) from the appliance as shown
in figure E.
• Remove the pleated filter (18) by pulling firmly (figure F).
• Tap the filters vigorously to remove loose dust.
• If necessary, wash the filters in warm, soapy water.
• Make sure that the filters are dry.
• Refit the pleated filter (18) into the dust container.
• Refit the pre-filter (17) into the dust container.
• Close the transparent door (7) and make sure that it
clicks into place.
TROuBLESHOOTING
If the product does not work, check the following:
• The charger was correctly plugged in for recharge. (It
feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly
attached to the appliance.
• The charger is plugged into a working electrical outlet.
• The appliance was switched to the off position to
charge. The battery will not be charged with the switch
in the "on" position.
• The filter is clogged. Pull the door latch and open the dust container door. Remove
the pre-filter and the fine filter. Brush any loose dust off the filters and wash them in
warm, soapy water. Make sure the filters are dry before placing back in the vacuum.
For assistance with your product, visit our website www.blackanddecker.com for the location of
the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.
BATTERy REMOVAL AND DISPOSAL
This product uses Lithium Ion rechargeable and recyclable batteries. When the
batteries no longer hold a charge, they should be removed from the Vac and recycled.
They must not be incinerated or composted.
The batteries can be taken for disposal to a Black & Decker, Company-Owned or
Authorized Service Center. Some local retailers are also participating in a national
recycling program (see "RBRC
the batteries to a Black & Decker Company-Owned or Authorized Service Center,
the Center will arrange to recycle old batteries. Or, contact your local municipality for
proper disposal instructions in your city/town.
To remove the battery pack for disposal:
1.) First, before attempting to disassemble the product, turn it
on and leave it on until the motor completely stops insuring a
complete discharge of the batteries.
2.) Invert the appliance to get access to the screws
that attach the base.
3.) Remove the four screws (19) shown in (figure G)
4.) Remove the base.
5.) Disconnect the 3-pin connector.
6.) Place the battery in suitable packaging to prevent a short
circuit of the battery terminals.
7.) Dispose of batteries as per recommended guidelines.
(figures E,F)
TM
Seal"). Call your local retailer for details. If you bring
7
E
F
G
19
19
17
18