KENMORE ELITE 415.16139111 Manual De Uso página 12

Main Burner ignitor Lighting
* Open grill lid during Lighting.
* Do not lean over grill while lighting.
1. Turn OFF all Gas Burner Control Valves.
2. Turn ON gas at LP cylinder.
3. To ignite any main burner, push in and turn the burner
control knob to the _ position.
4. Press and hold the ELECTRONIC iGNiTOR button until
the burner ignites.
5. Once burner has ignited, turn knob to desired setting.
6. If Ignition does not occur in 5 seconds, turn the burner
control to OFF, wait 5 minutes for gas to clear away, and
repeat the lighting procedure.
7. Repeat steps 4 through 6 for the remaining main burners.
Searing Burner ignitor Lighting
* Do not lean over grill while lighting.
* Open lld during lighting.
1. Turn on gas at LP cylinder.
2. To ignite the searing burner, push in and turn the searing
burner control knob to the _ position.
3. Press and hold the ELECTRONIC iGNiTOR button until the
searing burner ignites.
4. Once searing burner has ignited, turn knob to desired
setting.
5. If Ignition does not occur in 5 seconds, turn the burner
control to OFF, wait 5 minutes for gas to clear away, and
repeat the lighting procedure.
Rotisserie Burner ignitor Lighting
* Do not lean over grill while lighting.
1. Open grill lld during lighting. Turn on gas at LP cylinder.
2. To ignite the rotisserie burner, push in and turn the
rotisserie burner control knob to the _ position.
3. Press and hold the ELECTRONIC iGNiTOR button until the
rotisserie burner ignites.
4. Once burner has ignited, turn knob to desired setting.
5. If ignition does NOT occur in 5 seconds, turn the burner
control OFF. Wait 5 minutes for gas to clear away, and
repeat the lighting procedure.
Turn controls and gas source or tank OFF when not
in use.
CAUTION
if ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure, if the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury,
Match-Lightlng
* Do not lean over grill while lighting.
* Open lld. Turn on gas at LP cylinder.
* Light Burners one at time.
Match Lighting the Main Burners
1. Place match into match holder (hanging from RH side or
LH side of the cart).
2. Strike the match and position lit match through cooking
grates as shown in Figure A.
3. Position lit match next to far left main burner.
4. Push in and turn far left control knob to _ position. Be
sure burner lights and stays lit.
5. If ignition does NOT occur in 5 seconds, turn the burner
control knob OFF, wait 5 minutes for gas to clear away
and repeat the lighting procedure.
6. Light other burners in sequence from left to right by
pushing main burner control knob in and turning to
position.
Figure A
Match-Lightlng the Searing Burner
* Do not lean over grill while lighting.
* Open lld. Turn on gas at LP cylinder.
1. Place match into match holder (hanging from RH side of
the cart).
2. Strike the match and position lit match through cooking
grates as shown in Figure B.
3. Position lit match above the burner.
4. Push in and turn searing burner control knob to
position. Be sure burner lights and stays lit.
5. If ignition does NOT occur in 5 seconds, turn the burner
control knob OFF, wait 5 minutes for gas to clear away
and repeat the lighting procedure.
Match lighting the Rotisserie Burner - Figure C
1. Place match in match holder. Strike the Match. Position lit
match close to the front center of the rotisserie burner.
2. Push in and turn rotisserie burner control knob to
3. If ignition does NOT occur in 5 seconds, turn the burner
control knob OFF, wait 5 minutes for gas to clear away,
and repeat the lighting procedure.
12 " 464224212
Figure C
Match Lighting instructions continued on next page.