Publicidad
Idiomas disponibles
Idiomas disponibles
Side
burner
Ignitor
Lighting
Do not lean over grill while
lighting.
1. Open side burner
lld. Turn ON gas at LP cylinder.
2. Turn side burner knob to the Hi position,
push and hold
ELECTRONIC
IGNITOR
button.
3. If side burner does NOT light within
5 seconds, turn knob
to OFF, wait 5 minutes, then repeat lighting
procedure.
Match lighting the Side Burner - Figure D
1. Open the side burner lid during
lighting.
2. Place match in match holder. Strike the Match.
Position
lit match close to the side burner.
3. Push in and turn side burner knob to _
position.
Be sure
burner lights and stays lit.
4. If ignition
does NOT occur in 5 seconds, turn the burner
control
knob OFF, wait 5 minutes for gas to clear away,
and repeat the lighting
procedure.
Burner
Flame
Check
• Remove cooking grates and flame tamers. Light burners, rotate
knobs from HIGH _
to low. You should see a smaller flame in
low position than seen on HIGH Perform burner flame check on
side burner, searing burner and rotisseriealso. Always check flame
prior to each use. If only low flame is seen refer to "Sudden drop
or low flame" in the Troubleshooting Section.
Turning
Grill Off
" Turn all knobs to OFF position.
Turn LP cylinder
off by turning
hand-wheel
clockwise
to a full stop.
Ignitor
Check
' Turn gas off at LP cylinder.
Push and turn control knob to
and hold in. You will hear a clicking sound as the burner is being
ignited. Ignition should occur within 5 seconds, but continue to
hold the knob in for a full 10 seconds to maintain ignition.
Valve
Check
* ffnportant:
Make sure gas is off at LP cylinder
before
checking
valves.
Knobs lock in OFF position.
To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace
valve assembly
before using grill. Turn knobs to LOW position
then turn
back to OFF position.
Valves should turn smoothly.
Hose Check
" Before each use, check to see if hoses are cut or worn.
Replace
damaged
hoses before using grill. Use only
valve/hose/regulator
specified
by manufacturer.
CAUTION
SPIDER ALERT!
if you notice that your grill is getting hard to light or that the
flame isn't as strong as it should be, take the time to check ant
clean the burner tubes. See section "Cleaning Burner
Assemblies" next page.
CONTROL PANEL_
SPIDER
WEBS
/
INSIDE
BURNER TUBE
il
BURNER
i
Spiders or small insects have been known to create
"flashback"
_roblems. The spiders
spin webs, build nests and lay eggs in the
grill's venturi tube(s) obstructing
the flow of gas to the burner.
The backed-up
gas can ignite in the burner tube behind the
control
panel. This is known as a flashback
and it can damage
your grill and even cause injury.
To prevent flashbacks and ensure good performance
the burner and
burner tube assembly should be removed from the grill and cleaned
before use whenever the grill has been idle for an extended period.
J
CAUTION
Do not remove glass for deanlng.
Glass is not dishwasher
safe.
464224212
" 13
Publicidad
