Avermedia C285 Manual De Usuario página 31

Step 2
A/V Pass Thru.
It is suggested that A/V Pass Through to be turned
ON.
Step 3 (1)
Reminder
Make sure a NTFS-formatted hard drive is
connected or installed to the device. (For details,
see Chapter 4.2)
Check the connection of network.
Press OK to start setup.
A router which supports DHCP IP network is
recommended. Also, refer to Ch. 6.2 for Manual
connection setup.
Step 3 (2)
Network Connection Failure
If you have not connected to a valid network, a short
result of failed network connection will be shown.
Press OK to continue.
Press to go back to the previous page.
English-26