Adjustment And Replacement Of The Mandrel Rotation Belts; Greasing Points - Bosch TCE 5310 Instrucciones De Reparacion

en 24 | TCE 5310 - TCE 5320 | Adjustments
4. With an allen wrench remove the four fixing screws
and consequently the whole electrovalve;
5. Clean with a dry and clean cloth the residual oil on
the electrovalve base;
6. Do the same thing on the electrovalve surface;
7. Insert the valve, paying attention to place it in the
same position of the removed one;
8. Insert and screw the four fixing screws of the elec-
trovalve;
9. Insert and screw the protection caps on the coils of
the electrovalves;
10.
Power up the machine and try if it works correctly.
3.4 Adjustment and replacement of the
mandrel rotation belts
Belts tension adjustment:
1. Disconnect the machine from power supply;
2. Remove the belts protection cover;
3. Test manually belts tension, if too loose operate as
follows:
$
Loosen the counter-nut on the motor;
$
Operate on the screw itself in order to restore the
correct tension;
$
Tighten with the counter-nut.
Belts replacement:
1. Disconnect the machine from power supply;
2. Remove the belts protection cover;
3. Loosen the counter-nut on the motor;
4. Operate on the screw itself to loosen tension com-
pletely, in order to make it easier to replace the
belts;
5. Remove both belts from the pulleys;
6. Check the exact correspondence between the new
belts and the old ones;
7. Place the new belts on the pulleys;
8.
Operate on the screw on the motor in order to re-
store the right tension;
9. Tighten with the counter-nut.
|
1 695 301 856 2008-10-17
3.5

Greasing points

Grease periodically the machinery in the indicated
points:
Robert Bosch GmbH