Description Of The Controls - Rowenta PROCERAM Manual Del Usuario

SO9040_NC00015975_NC00015975 17/06/10 09:27 Page7
Please read the instructions for use and the safety precautions carefully before using your appliance for the first time.
1- WARNINGS
It is essential that you read these instructions carefully and comply with the following recommendations:
• For your safety, this appliance complies with the applicable standards and regulations (Low Voltage, Electromagnetic Compatibility, Environmental
directives, etc.)
• Before use, always check the condition of the appliance, the plug and the power cord.
• This appliance is not intended to be used by persons (including children) with reduced physical, sensory or mental capacities
or lack of experience and knowledge, unless they are supervised or have been given instructions beforehand concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure they do not play with the appliance.
• This appliance is designed for domestic use only. It should not be used for industrial applications.
• Do not use your appliance in a dusty room or a room where there is a risk of fire.
• Never insert objects into the appliance (e.g. needles)
• Do not place the appliance directly beneath an electrical wall socket.
• Do not pull on the power cord or the appliance itself to unplug it from the wall socket.
• Fully unwind the power cord each time before use.
• The warranty will be invalidated if damage occurs due to incorrect use.
• If the power cord is damaged, it must be replaced by the manufacturer, the after-sales service or a person with similar qualifications to avoid any
danger.
VERY IMPORTANT
• Warning: to avoid any risk of overheating, NEVER COVER THE PPLI NCE.
• Do not use this appliance near a bath, shower, sink or swimming pool.
• The appliance should not be used in a damp area.
• Do not use the appliance close to flammable objects or products (curtains, aerosols, solvents, etc.)
• Never use the appliance in an inclined or horizontal position.
• Do not touch the appliance with wet hands.
• Never allow water to enter the appliance.
• DO NOT ATTEMPT TO FORCE THE APPLIANCE TO ROTATE.
• If you are away for a long period: switch off the appliance, using the Stop button (E) and unplug it.
• The installation of the appliance and its use must always comply with the regulations in force in your country.
2- VOLTAGE
• Before using the appliance for the first time, make sure your mains voltage is the same as that indicated on it and that the electrical installation is
correct for the power rating shown on the appliance.
Your appliance can be used with a power plug without an earth connection. It is a class II appliance (double insulation
3- SAFETY
Overheating:
• In the event of overheating, a safety device automatically shuts down the appliance and then restarts it automatically once it has cooled down.
If the fault persists or becomes more serious a thermal fuse switches off the appliance definitively. It will then need to be taken to an approved ser-
vice centre.

4- DESCRIPTION OF THE CONTROLS

ON / OFF switch:
Your appliance is equipped with an ON/OFF switch (E) located at the base of the appliance at the back.
Control panel:
The control panel ( ) located on the top of the appliance has 6 buttons:
• Stand by / Start button
• MODE Operating mode button with 4 options:
- : This operating mode allows you to set the desired temperature for the room. The appliance will automatically set the operating power
AUTO
according to the temperature of your room and the temperature you have set.
- Cold ventilation, allows you to use your appliance as an extra cooling fan in summer.
- Operation at a power rating of 1000W, temperature not set (a safety device will limit the temperature of the room to 36°C).
- Operation at a power rating of 2000W, temperature not set (a safety device will limit the temperature of the room to 36°C).
• TIMER Button: llows the appliance to be set to operate for a given length of time.
Can be set from 1 to 7.5 hours.
• and buttons: 2 buttons for setting the temperature in
• button: allows the appliance to rotate in order to optimise the diffusion of hot or cold air in the room.
Remote control:
Your appliance is equipped with a remote control (J) on which you can find the
The information is transmitted to your appliance by an infra red beam, using an emitter diode at the front of the remote control. The infrared recei-
ver is located next to the display screen on the appliance.
Take care not to scratch the emitter diode, or the infra red receiver of the appliance.
When using the remote control, point the emitter diode towards the infra red receiver of the appliance and press the desired buttons (see § OPER -
TION).
Ensure that there are no obstacles between the emitter diode and the receiver.
The maximum range is approximately 6 metres from the appliance.
temperature of 24°C is the default setting.
AUTO mode and for TIMER settings.
, ,
MODE
7
).
, , and buttons.
TIMER
GB