Operating Modes - Rowenta PROCERAM Manual Del Usuario

SO9040_NC00015975_NC00015975 17/06/10 09:27 Page8
Remote control power supply:
- The remote control operates with 2 1.5V
- Place the batteries in the compartment respecting the polarities indicated in the compartment.
Display screen:
Your appliance is equipped with a display screen (C) on which you can find the following information:
C1 - Temperature (in °C):
• when you switch on the appliance using the ST RT button, the room temperature will be
displayed.
• in UTO mode you select the temperature you want; it will flash for a few seconds and
then the room temperature is displayed.
C2- Display of the operating mode selected
C3- TIMER function, with the number of hours programmed
5- OPERATION
Before switching on your appliance ensure that:
- The appliance is positioned as described in the instructions
- The air intake and outlet grills are completely unobstructed
- The appliance is upright and on a firm surface
A. ON / OFF:
To switch on your appliance:
- First press the ON/OFF switch (E) located on the base of the appliance at the back.
Your appliance is switched on (in stand by mode), the room temperature can be seen on the screen.
- Then press the button on the control panel or the remote control.
Your appliance starts and the display screen lights up.
The appliance will beep every time the command buttons are pressed.
To switch off your appliance:
WARNING: When the appliance is switched off in the heating MODE (
ment.
- Press the button on the control panel or the remote control.
Your appliance is still powered (in stand by mode).
- To switch the appliance off completely, press the ON/OFF switch (E) located on the base of the appliance at the back.
B. OPERATING MODES
Press the button to select the operating mode.
MODE
AUTO
On the screen the operating mode indicator selected is lit up.
• B1. AUTO MODE
Press the or buttons on the control panel or the remote control to set the desired temperature (from 15°C to 35°C), according to personal prefe-
rence.
There is no need to press any other buttons to confirm, this is done automatically.
On the display screen you will see:
- The operating mode AUTO and the temperature you have just set.
- fter a few seconds the temperature you have set disappears and you will see the room temperature.
- To view the temperature you have set, simply press the
Note: If the temperature you have set is lower than the room temperature (measured by the appliance) then the appliance will automatically stop.
The AUTO symbol on the display screen then flashes. The appliance will start heating again automatically as soon as the room temperature drops
below the temperature set.
• B2. MODE
The appliance operates in cooling mode.
You cannot set the temperature in this operating mode.
On the display screen you will see:
- The mode symbol and the room temperature.
• B3. MODE
The appliance operates at a power rating of 1000W (no temperature setting).
You cannot set the temperature in this operating mode.
On the display screen you will see:
- The mode symbol and the room temperature.
or LR03 type alkaline batteries, not provided.
, ,
AUTO
or buttons.
8
C1
C2
), the fan runs for a further 30 seconds to cool the heating ele-
GB
C3