Electrical - JENN-AIR JXT7036ADS Guia De Instalacion

INSTALLATION
Mounting the Range Hood
1. Determine and mark the mounting
position of the range hood with a
pencil.
2. Cut out the opening where the
range hood will be installed.
3. Install ductwork and electrical.
Duct tape all duct connections
with certified duct or silver tape.
4. Position range hood into location.
Apring loaded latch on one side,
will lock into position to help
support the hood.
5. Supporting the other end of the
hood, fasten wood screws through
pre-drilled holes into wood frame
opening.

ELECTRICAL

WARNING
All Electrical work must by performed by qualified electrician or person with similar technical know how and
background.
For personal safety, remove house fuse or open circuit breaker before beginning installation.
Do not use extension cord or adapter plug with this appliance.
Follow National electrical codes or prevailing local codes and ordinances.
Electrical Supply:
This appliance requires a 120V 60Hz electrical supply and connected to an individual, properly grounded branch
circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring must be 2 wire w/ ground.
Please also refer to Electrical Diagram labeled on product.
Cable Lock:
A cable locking connector (not
supplied) might also be required by
local codes. Check local
requirements and codes, purchase
and install appropriate connector
if necessary.
INSTALLATION
Cable Lock
duct/silver
tape
Ductwork connection
Power supply cable
Locking latch
Entry into range hood
5
Screw in place