Trevi TT 1040 BT Manual De Instrucciones página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

ENGLISH
POWER
Insert the plug into the wall socket AC 230V - 50Hz. Do not connect the appliance to sockets with a voltage other than specified.
ON / OFF / VOLUME
1. To turn on the appliance, turn the power switch (23) to position I.
2. To turn off the appliance, turn the power switch (23) to position O.
3. Adjust the volume using the Volume Control (18).
OPERATION RADIO AM / FM
1. Turn the rotary switch (8) on the AM position for listening to AM or FM radio for listening to FM radio.
2. Tune to the desired station with the tuning control (7).
NOTE: - For the best FM reception extend and adjust the antenna (21). If the reception is not good try adjusting different length and orientation
of the antenna. The quality of the FM reception depends on the place where you place the unit.
- The proximity of TV sets, fluorescent lamps or other appliances may cause interference to radio programs, in this case the radio cassette
removed from the equipment which disturbs.
AUX IN
1. Turn the dial (8) to the AUX position.
2. Connect any unit equipped with audio output through a special 3.5mm jack cable (not included) to the AUX IN (10).
3. Operate the external unit by their commands.
BLUETOOTH OPERATION
1. Turn the rotary switch (8) on the BT position.
2. In Bluetooth mode, the system automatically goes into research.
3. Activate the Bluetooth feature on the external device to be connected and make it visible.
4. Initiate a search for devices. At the end match the "TT 1040 BT device".
5. Enter the password "0000" if necessary.
6. Start playing music from your device.
TURNTABLE OPERATION
1. Turn the dial (8) to position PH.
2. Open the turntable cover (1) and secure using the retaining clip (2).
3. Select the correct drive speed (33/45/78 rpm) via the selector speed turntable (7).
4. Place the disc on the turntable. Use the supplied adapter (3) if the disc is a 45.
5. Release the arm from the locking hook (9); raise your arm and place the needle on the record, pull the lever (4) to lower the head arm.
NOTES:
- Remove the turntable needle before use protection.
- Make sure that the arm is locked with the latch before and after use.
- Some discs may stop before the end, because the area of the disk does not match the settings of this unit. In that case, set the mode dial
AUTO STOP (6) to OFF. In this way, the disc will play to the end, but will not stop automatically.
USB PLAYER
1. Insert a USB device in the entrance (19).
2. Press the switch (12) to activate the USB player, playing music will start 'automatically.
3. Press the PLAY / PAUSE button (14) to pause, press it again to resume play.
4. Press and hold the PLAY / PAUSE button (14) on the unit to stop playback.
5. Press the NEXT button (15) during playback to go to the next track.
6. Press the PREV button (13) during playback to go to the previous track.
HEADPHONES JACK
1. Plug the headphone jack into the socket (9), the speakers will be disabled.
OUTPUT LINE OUT
1. It's possible, through a RCA Stereo cable (not supplied) to connect the Line Out output to an external amplifier.
TECHNICAL FEATURES
Power supply:
Consumption:
Dimensions:
Frequency band FM:
Frequency band AM:
AC 230V - 50Hz
18W
480 x 320 x 255 mm (L x W x H)
87.5-108MHz
530-1600KHz
7
TT 1040 BT

Publicidad

Tabla de contenido
loading

Tabla de contenido