Service - Troy-Bilt Flurry 1400 Manual Del Operador

Service

WARNING:
the key to avoid unintended starting before
servicing the snow thrower.
Replacing Skid Plate
1. Remove the three screws securing the skid plate to the
auger housing. See Figure 7-1.
2. Remove the worn skid plate and replace with a factory
approved skid plate.
3. Secure using the three screws removed earlier.
15
Unplug the snow thrower and remove
Side View
Figure 7-1
Replacing Auger Belt
1. Unscrew the six screws securing the belt cover to the auger
housing and remove the belt cover. See Figure 7-2.
Figure 7-2
2. Pull the idler bracket upward to relieve tension on the belt.
See Figure 7-3
CAUTION:
Do not unhook the idler extension
spring. Doing so may allow the spring to become
dislodged and lost in the auger housing.
Pulley B
Idler Bracket
Pulley A
Figure 7-3
7