Service; Belt Replacement - Troy-Bilt 2690XP Manual Del Operador

Service

Belt Replacement

Auger Belt
To remove and replace your snow thrower's auger belt, proceed
as follows:
1. Allow the engine to run until it is out of fuel. Do not
attempt to pour fuel from the engine. Remove the safety
key to avoid unintended starting.
2. Remove the plastic belt cover on the front of the engine by
removing the two self-tapping screws (a). See Figure 7-1.
(a)
Figure 7-1
3.
(a)
4.
Loosen and remove the two bolts (a) and flat washers (b)
securing the belt guide. See Figure 7-2. Remove belt guide.
Figure 7-2
Roll the auger belt off the engine pulley. See Figure 7-3.
Figure 7-3
7
(b)
(a)
(b)
(a)
19